Skip to content
White Rose Door & Opener Co.Request a visit
Open 24/7(289) 802-4769Call now
Two detached black sensors with recessed lenses and coiled wires lie in a tray beside a mounting bracket. — Photo-Eye Sensor Alignment or Replacement, Aurora

Book soon Openers · Aurora

Photo-Eye Sensor Alignment or Replacement

The door will only go down while a finger stays on the wall button; let go and it stops or reverses. From the remote it opens fine but never closes, so someone has to stand in the garage every time.

Call now · open 24/7(289) 802-4769

Request a visit

Right now

Before the door is looked at

Call (289) 802-4769, open 24/7.

  1. Never bypass, tape over or relocate the sensors to make a door close; a door that reverses is reporting something worth fixing.

In plain words

By the end of the visit you have a door that closes from every control and reverses the instant the beam is broken, a sensor pair mounted level at the right height with steady indicator lights, wiring that is secured and out of harm's way, and a written note of what was found and what was changed. The technician walks you through the two tests you can repeat monthly, points out which light is which, and leaves the opener's diagnostic chart where you can find it. It is a small job that puts a large piece of your door's protection back in service.

Sound familiar?

The small light on one of the sensors near the floor has gone dark, or it flickers when someone walks past the track. The other one glows steadily. The door refuses to close from the car.

How the visit goes

Photo-Eye Sensor Alignment or Replacement · Aurora

How the visit goes

Technician holding a black decorative strap hinge on a beige paneled garage door and driving a screw with a yellow drill.
  1. 1

    Clearing and walking the beam

    Before anything is adjusted, the technician clears the strip of floor between the two sensors and looks along the beam line at sensor height. Things that break a beam are rarely dramatic: the corner of a recycling bin, a hose left coiled by the wall, a bag of salt, leaves blown in under the door, a cobweb bridging a lens, a new weatherstrip or track shoe that sits a little proud. Snow and ice piled inside the door in winter count too. With the path clean, the door is tried again, because a fair share of sensor calls end right here, with a lesson about where things can and cannot sit.

  2. 2

    Bringing the pair back to the doorway

    Sometimes the sensors exist but have been defeated: taped face to face next to the head unit so the circuit is always satisfied and the door closes on anything. The technician separates the pair, checks that both still work, and mounts them where they belong on each side of the opening, low to the floor and facing each other. New wire is run down each side, brackets are fitted, and the alignment is set. The opener is then made to prove itself with the beam test, and the household is shown why the pair matters and how to keep it working, so the shortcut is never tempting again.

  3. 3

    A door that closes from the driveway again

    The change you notice first is the ordinary one: you press the remote from the car, the door goes all the way down, and nobody has to stand in the garage holding a button. Behind that is a beam that is once more crossing the doorway at the right height, a pair of sensors that agree with each other, and an opener that is no longer flashing a warning every time you ask it to close. The door still stops and returns to open whenever the beam is broken, which is exactly what it should do, and now it does that only when something is genuinely in the way.

In the van

  • 2x4 test block
  • Multimeter
  • Wing nuts and carriage bolts
  • Insulated wire staples
  • Two-conductor low-voltage wire

What affects the quote

  1. 1

    Bracket condition

    A bracket that can be straightened costs little time. One that is cracked, rusted through or missing is replaced, and a change from track clips to wall or floor brackets adds anchors and mounting work.

  2. 2

    Alignment or replacement

    Cleaning, re-aiming and refastening the existing pair is the smaller job. Fitting a new matched sending and receiving pair is the larger one, and the diagnosis at the door decides which applies before the quote is settled.

  3. 3

    Door-side findings

    A balance problem, a stiff roller or a bottom seal that needs replacing sometimes shows up during testing. Those belong to their own service and are noted and quoted separately rather than hidden in the sensor work.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(289) 802-4769

Photo-Eye Sensor Alignment or Replacement: questions

Advice · (289) 802-4769

How should I clean the lenses?

Gently, with a soft dry or lightly damp cloth, the way you would clean eyeglasses. Never scrape a lens or use a solvent, since a scratched or clouded lens scatters the beam. Wipe both sensors, then check that the receiving light comes on steadily. If a lens frosts on cold mornings, give it a few minutes to clear or dry it with a cloth. A quarterly wipe keeps dust, cobwebs and salt film from building up.

What can I check myself before calling?

Three things, all safe. Look along the floor between the sensors for anything in the path, including snow, leaves or a cobweb across a lens. Look at the two sensor lights and note whether one is dark or flickering, or both are dark. Press close and count the flashes of the opener light. If moving an object or wiping a lens brings the receiving light back on steadily, the door may close normally again; if not, those observations make the visit shorter.

My opener has no sensors at all. Can they be added?

If the opener predates the entrapment-protection standard, which operators have had to meet since the mid-1990s, its board has no sensor circuit and a pair cannot simply be wired in. The positive news is that a modern operator brings the whole package: matched sensors, force reversal and a monitored circuit. The technician confirms the model first, because some units do have the terminals and simply had their sensors removed.

York, Ontario

Aurora information

Town
Aurora, York, Ontario
In business
21 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

22%

Newer homes. About 22% of homes in Aurora were built in 1980 or earlier, according to the 2021 Census.

Many newer homes have a keypad by the door, several remotes and an app that reports whether the door is open. We keep all of these talking to the opener, clear codes from devices that have gone missing and set up new ones so the whole household is covered.

60%

Mostly houses. Single-detached houses make up about 60% of homes in Aurora (2021 Census).

Single-detached homes give a technician room to work: a driveway for the van, side room beside the tracks and a clear header. That means spring replacement, opener installation and full door replacement can each be finished in one visit with the door properly secured throughout.

Source: Statistics Canada, 2021 Census of Population

Open Aurora in Google Maps

Open 24/7

Request a visit

The door will only go down while a finger stays on the wall button; let go and it stops or reverses.

Call now · open 24/7(289) 802-4769
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 21 years in business